Engine Misfire UK: Causes + Ignition Coil Cost (£80–£400)
← Back to the Knowledge Hub

Engine Misfire: Causes, Ignition Coil Replacement Cost and What to Do

Repair Costs · 10 min read · Updated

A misfire feels like the engine has a hiccup. The car shudders at idle, hesitates when you put your foot down, or loses power on a hill, and the engine management light often comes on or starts to flash. Most misfires come down to something small and affordable, such as a tired spark plug or a failed ignition coil. Left alone, though, a misfire can wreck a catalytic converter worth far more than the original repair. Here is what causes an engine misfire, how a garage finds the culprit, what each fix typically costs in the UK, and where a warranty fits in.

What is an engine misfire?

A petrol engine makes power by squeezing a mix of air and fuel in each cylinder and lighting it with a spark at exactly the right moment. A diesel does the same thing without a spark, relying on the heat of compression. A misfire happens when one or more cylinders fail to burn their charge properly. The engine loses that cylinder's push, so it runs unevenly, and the unburnt fuel goes straight out into the exhaust.

Modern engines watch for this constantly. The engine control unit measures tiny changes in crankshaft speed, and when a cylinder stops pulling its weight it logs a fault code and switches on the engine management light. If the misfire is bad enough to put the catalytic converter at risk, the light flashes.

Signs your engine is misfiring

The most common causes of a misfire

A misfire has three possible roots: no spark, the wrong amount of fuel, or not enough compression. In practice the cheap causes are far more common than the expensive ones.

Worn spark plugs

Spark plugs wear slowly, and the gap the spark has to jump gets wider. Eventually the coil cannot produce a strong enough spark, especially under load. Most modern plugs are due every 40,000 to 60,000 miles or every four to six years, but some engines need them more often. Oil on the plug, from a leaking rocker cover gasket or worn piston rings, can also cause a misfire.

Failed ignition coils

Most petrol cars built in the last twenty years have a separate coil pack sitting on top of each spark plug. Coils live in a hot, vibrating place, and the insulation inside them eventually cracks. A failing coil often works fine when the engine is cold and starts to misfire once it heats up, or misfires only in heavy rain. Some engines are known for it, including several small turbocharged petrol engines from VW Group, Ford and Vauxhall.

Fuel injector faults

An injector that sticks, leaks or sprays badly gives a cylinder too much or too little fuel. On a diesel this is the most likely cause, because there is no spark to go wrong. Our fuel injector replacement cost guide covers symptoms and prices in detail.

Air leaks and sensor faults

A split intake hose, a perished vacuum pipe or a faulty air flow sensor lets the engine run lean, which can cause a random misfire across several cylinders. These faults often show up as fault code P0300 alongside lean codes such as P0171.

Low compression

The least common and most serious cause. A burnt valve, a worn camshaft, a slipped timing belt or a failing head gasket stops a cylinder holding pressure. A garage confirms this with a compression test, and the repair can run into four figures.

How a garage finds the cause

A good garage does not just fit parts until the problem goes away. The usual steps are:

  1. Read the fault codes. P0301 to P0308 point to a specific cylinder. P0300 means random or multiple cylinders.
  2. Check live data. Misfire counters for each cylinder show how often each one is dropping out.
  3. Swap the coil. The coil from the misfiring cylinder is swapped with a neighbour. If the misfire moves, the coil is faulty. If it stays, the plug or injector is next.
  4. Inspect the spark plugs. Their condition tells a story: oily, sooty, cracked or simply worn out.
  5. Compression or leak-down test if the cheaper checks find nothing.

Expect to pay around £50–£100 for diagnosis at an independent garage. Many garages will knock that off the bill if they do the repair.

How much does it cost to fix a misfire in the UK?

These are typical prices at independent UK garages in 2026, including parts, labour and VAT. Main dealers usually charge more, and engines where the inlet manifold has to come off to reach the rear plugs and coils cost noticeably more.

RepairTypical cost
Diagnostic check£50–£100
Spark plugs (four-cylinder)£80–£200
Spark plugs (V6, intake removal)£200–£400
One ignition coil£80–£250
Full set of coils (four-cylinder)£150–£400
HT leads and distributor-type coil (older cars)£80–£200
Vacuum hose or intake leak£60–£200
One fuel injector (petrol)£150–£400
One diesel injector, coded£250–£600
Valve or head work after low compression£800–£2,500

These figures are our estimates for typical UK garage prices, not ClearPath claim figures. Your price depends on the engine, how easy the parts are to reach, and whether you choose original-equipment or quality aftermarket parts.

Is it safe to drive with a misfire?

A mild misfire with a steady engine light is not usually an emergency, but book the car in within a few days. The danger is not the misfire itself but what the unburnt fuel does further down the exhaust. It burns inside the catalytic converter, which can overheat, melt inside and block the exhaust. A new catalytic converter often costs £500–£1,500, so a £150 coil left for a month can become a much larger bill.

If the engine light is flashing, ease off, avoid motorway speeds and hard acceleration, and get the car looked at straight away. If the car is juddering badly, losing power or smells strongly of fuel, stop and call for breakdown help. A car with an engine light on will also fail its MOT, which our guide to common MOT failures explains.

Does a car warranty cover an engine misfire?

It depends on what caused it. A good mechanical and electrical breakdown warranty separates parts that fail suddenly from parts that simply wear out with use:

Every policy is different, so read the What Is Covered schedule and call for authorisation before a garage starts work. Our guide to making a warranty claim walks through the process step by step, and what counts as wear and tear explains why some parts are treated differently.

How to prevent misfires

The bottom line

Most misfires are caused by spark plugs or an ignition coil, and most fixes cost between £80 and £400 at an independent garage. The expensive mistake is to keep driving with a flashing engine light and turn a small electrical fault into a new catalytic converter. Get the codes read, let the garage test before it replaces, and check whether your warranty covers the part before work starts. To see what cover costs for your car, get an instant quote.

Frequently Asked Questions

How much does it cost to replace an ignition coil in the UK?

A single ignition coil usually costs £80–£250 fitted at an independent garage, including parts, labour and VAT. Replacing all the coils on a four-cylinder engine typically costs £150–£400, and V6 or V8 engines where the intake has to come off can cost more.

Can I drive with an engine misfire?

You can usually drive gently to a garage if the misfire is mild and the engine light is steady. If the engine light is flashing, slow down and stop as soon as it is safe, because unburnt fuel is going into the exhaust and can overheat and destroy the catalytic converter.

What is the most common cause of a misfire?

On petrol cars the most common causes are worn spark plugs and failed ignition coils. On diesels, which have no spark plugs, a faulty injector is the usual suspect. Vacuum leaks, low compression and wiring faults are less common.

Should I replace all the ignition coils at once?

Not always. If one coil fails on a car with high mileage, many garages suggest replacing all of them because the others are the same age, and it saves paying labour twice. On a low-mileage car, replacing only the failed coil is usually fine.

How do I know which cylinder is misfiring?

A diagnostic scan reads fault codes such as P0301 to P0304, where the last digit is the cylinder number. P0300 means a random or multiple misfire. A garage then swaps the coil to another cylinder to see whether the fault follows it.

Does a car warranty cover an engine misfire?

Spark plugs are service items and are not normally covered, but ignition coils, injectors and engine sensors that fail suddenly are often covered by a mechanical and electrical breakdown warranty. Check the What Is Covered schedule for your policy and get authorisation before any work starts.

Written by the ClearPath Protection Editorial Team

Our guides are written and checked by the people who handle ClearPath cover day to day — a team led by a founder who worked as a mechanic before running dealerships for Fiat, Alfa Romeo, Nissan, Volkswagen and Jaguar Land Rover, alongside the claims staff who assess these repairs for a living. Meet the team.

Related reading

Ready to see what cover costs for your car?

Get a no-obligation quote and see the protection available for your vehicle.

Get a Quote

Important information. This article is general information about how vehicle warranties work in the UK. It is not a statement of your cover. Your Validation Certificate, Vehicle Warranty Terms and Conditions and What Is Covered schedule are the documents that decide what is and is not covered on your vehicle.

Get Quote